Dell S5248F-ON EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7 - Page 28
description VM_Network_B
![]() |
View all Dell S5248F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
S5248F-Leaf1A description vMotion no shutdown interface vlan1613 description vSAN no shutdown interface vlan1614 description VM_Network_A no shutdown interface vlan1615 description VM_Network_B no shutdown interface vlan3939 description Internal_Mgmt no shutdown ipv6 mld snooping querier S5248F-Leaf1B description vMotion no shutdown interface vlan1613 description vSAN no shutdown interface vlan1614 description VM_Network_A no shutdown interface vlan1615 description VM_Network_B no shutdown interface vlan3939 description Internal_Mgmt no shutdown ipv6 mld snooping querier 7.2.3 Configure interfaces Configure the interfaces for the jump box or laptop computer connections to be used during VxRail deployment. This example uses 10GbE interface 1/1/9:1 on each switch. Note: See Appendix B to change the native speed of S5248F-ON port groups from 25GbE to 10GbE for jump box or laptop computer connections. While only one connection to the jump box is required, two may be used for redundancy. Add these interfaces as access ports on VLAN 1611 (the External Management VLAN). Note: In this example, the jump box also provides DNS and NTP services as covered in Section 5.4. If these services are located on other devices, ensure the corresponding switch interfaces are also in the External Management VLAN. Configure the interfaces for connections to the VxRail nodes. Interfaces 1/1/17 through 1/1/20 are used in this example. Use the switchport mode trunk command to enable ports to carry traffic for multiple VLANs. Configure the ports as access (untagged) ports on VLAN 1611 (the External Management VLAN). Configure the ports as trunk (tagged) ports on VLANs 1612-1615 and 3939 (the vMotion, vSAN, VM Network, and Internal Management VLANs). Configure ports directly connected to nodes, servers, or other endpoints as STP edge ports. Set flow control to "receive on" and "transmit off" on node-connected ports as a best practice. 28 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
![](/manual_guide/products/dell-powerswitch-s3048on-emc-smartfabric-os10-switch-configuration-guide-vxrail-47-f1f669d/28.png)