Dell Studio XPS M1640 Service Manual - Page 40

Back to Contents Page Rear Caps Dell™ Studio XPS™ 1640 Service Manual Removing the Rear Caps Replacing the Rear Caps CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Before performing this procedures, turn off the computer, disconnect the AC adapter from the electrical outlet and the computer, disconnect the modem from the wall connector and the computer, and remove any other external cables from the computer. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer). NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the computer. Removing the Rear Caps 1. Follow the instructions in Before You Begin. 2. Remove the base cover (see Removing the Base Cover). 3. Push the rear caps to the side and then pull them out as shown in the figure. 1 rear caps (2) Replacing the Rear Caps 1. Align the hooks on the rear caps to the hinges and snap them in place. 2. Replace the base cover (see Replacing the Base Cover). 3. Slide the battery into the battery bay until it clicks into place. Back to Contents Page