Dell W-7030 AOS 6.4.x User Guide - Page 1101

Choose from existing configured policies, create a new policy based on existing policies, or create a new policy. a. If you elect to create a new policy, click on the radio button for Create New Policy and then click Create. The WebUI displays the Policies tab. b. In the Policies tab: Policy Name. Enter the policy name fortinet and the IPv4 Session policy type.) Click Add to proceed. The WebUI expands the Policies tab. In the drop-down lists, choose parameters such as source, destination, service in the same way as other firewall policy rules. This example uses any source, any destination, service type svc-http (tcp 80). For certain choices, the WebUI expands and adds drop-down lists. c. In the Action drop-down menu, select the redirect to ESI group option. Select fortinet as the appropriate ESI group. The three steps above translate to "for any incoming HTTP traffic, going to any destination, redirect the traffic to servers in the ESI group named fortinet.") Select both as the traffic direction. Forward refers to the direction of traffic from the untrusted client or user to the trusted server, such as the HTTP server or email server. To add this rule to the policy, click Add. d. Repeat the steps to configure additional rules. This example adds a rule that specifies any, any, any, permit. e. Click Done to return to the User Roles tab. 4. Click Apply to apply the configuration changes. 5. Refer to Roles and Policies on page 438, for directions on how to apply a policy to a user role. In the CLI Use these commands to define the redirection filter for sending traffic to the ESI server and apply the firewall policy to a user role in the route-mode ESI topology example. ip access-list session policy any any any redirect esi-group group direction both blacklist //For any incoming traffic, going to any destination, //redirect the traffic to servers in the specified ESI group. any any any permit //For everything else, allow the traffic to flow normally. user-role role access-list {eth | mac | session} bandwidth-contract name captive-portal name dialer name pool {l2tp | pptp} reauthentication-interval minutes session-acl name vlan vlan_id Syslog Parser Domain and Rules The following sections describe how to configure the syslog parser domain and rules for the route-mode example using the WebUI and CLI. In the WebUI Adding a New Syslog Parser Domain To add a new syslog parser domain for the routed example: 1101 | External Services Interface Dell Networking W-Series ArubaOS 6.4.x | User Guide