Dell W-7030 AOS 6.4.x User Guide - Page 727

1. Navigate to the Configuration > Wireless > AP Installation > Provisioning page. Select the remote AP and click Provision. 2. Under Authentication Method, select IPSec Parameters. Enter the Internet Key Exchange (IKE) PreShared Key (PSK), username, and password. The username and password you enter must match the username and password configured on the authentication server for the remote AP. 3. Under Master Discovery, set the Master IP Address as shown below: Deployment Scenario Deployment 1 Deployment 2 Deployment 3 Master IP Address Value Controller IP address Controller public IP address Public address of the NAT device to which the controller is connected The username and password you enter must match the username and password configured on the authentication server for the remote AP. 4. Under IP Settings, make sure that Obtain IP Address Using DHCP is selected. 5. Click Apply and Reboot. Deploying a Branch/Home Office Solution In a branch office, the AP is deployed in a separate IP network from the corporate network. Typically, there are one or two NAT devices between the two networks. Branch office users need access to corporate resources such as printers and servers, but traffic to and from these resources must not impact the corporate head office. Figure 98 is a graphic representation of a remote AP in a branch or home office, with a single controller providing access to both a corporate WLAN and a branch office WLAN. Figure 98 Remote AP with Single Controller 727 | Remote Access Points Dell Networking W-Series ArubaOS 6.4.x | User Guide