Dell W-7030 AOS 6.4.x User Guide - Page 438

Chapter 17 Roles and Policies The client in a Dell user-centric network is associated with a user role, which determines the client's network privileges, how often it must re-authenticate, and which bandwidth contracts are applicable. A policy is a set of rules that applies to traffic that passes through the Dell controller. You specify one or more policies for a user role. Finally, you can assign a user role to clients before or after they authenticate to the system. This chapter describes assigning and creating roles and policies using the ArubaOS CLI or WebUI. Roles and policies can also be configured for WLANs associated with the "default" ap-group via the WLAN Wizard: Configuration > Wizards > WLAN Wizard. Follow the steps in the workflow pane within the wizard and refer to the help tab for assistance. Topics in this chapter include: l Configuring Firewall Policies on page 438 l Creating a Firewall Policy on page 439 l Creating a Network Service Alias on page 443 l Creating an ACL White List on page 444 l User Roles on page 445 l Assigning User Roles on page 447 l Understanding Global Firewall Parameters on page 452 l Using AppRF 2.0 on page 458 This chapter describes configuring firewall policies and parameters that relate to IPv4 traffic. See IPv6 Support on page 198 for information about configuring IPv6 firewall policies and parameters. Configuring Firewall Policies A firewall policy identifies specific characteristics about a data packet passing through the Dell controller and takes some action based on that identification. In a Dell controller, that action can be a firewall-type action such as permitting or denying the packet, an administrative action such as logging the packet, or a quality of service (QoS) action such as setting 802.1p bits or placing the packet into a priority queue. You can apply firewall policies to user roles to give differential treatment to different users on the same network, or to physical ports to apply the same policy to all traffic through the port. Firewall policies differ from access control lists (ACLs) in the following ways: l Firewall policies are stateful, meaning that they recognize flows in a network and keep track of the state of sessions. For example, if a firewall policy permits telnet traffic from a client, the policy also recognizes that inbound traffic associated with that session should be allowed. l Firewall policies are bi-directional, meaning that they keep track of data connections traveling into or out of the network. ACLs are normally applied to either traffic inbound to an interface or outbound from an interface. l Firewall policies are dynamic, meaning that address information in the policy rules can change as the policies are applied to users. For example, the alias user in a policy automatically applies to the IP address assigned to a particular user. ACLs typically require static IP addresses in the rule. You can apply IPv4 and IPv6 firewall policies to the same user role. See IPv6 Support on page 198 for information about configuring IPv6 firewall policies. Dell Networking W-Series ArubaOS 6.4.x| User Guide Roles and Policies | 438