Dell W-7030 AOS 6.4.x User Guide - Page 780

In the WebUI Follow the procedure below to convert a group of APs to Spectrum mode via the WebUI. 1. Navigate to the Configuration > Wireless > AP Configuration window. Select the AP Group tab. 2. Click Edit by the name of the AP group you want to convert to spectrum monitors. 3. Under the Profiles list, expand the RF Management menu. 4. To enable a spectrum monitor on the 802.11a radio band, select the 802.11a radio profile menu. -orTo enable a spectrum monitor on the 802.11g radio band, select the 802.11g radio profile menu. 5. The Profile Details pane appears. Click the Mode drop-down list, and select spectrum-mode. 6. Click Apply. In the CLI To convert a group of APs via the command-line interface, access the CLI in config mode and issue the following commands, where is the 80211a or 80211g radio profile used by the AP group. rf dot11a-radio-profile mode spectrum-mode rf dot11g-radio-profile mode spectrum-mode Connecting Spectrum Devices to the Spectrum Analysis Client A spectrum analysis client is any laptop or desktop computer that can access the controller WebUI and receive streaming data from individual spectrum monitors or hybrid APs. Once you have configured one or more APs to operate as a spectrum monitor or hybrid AP, use the Spectrum Monitors window to identify the spectrum devices you want to actively connect to the spectrum analysis client. To connect one or more spectrum devices to your client: 1. Navigate to Monitoring > Spectrum Analysis. 2. Click the Spectrum Monitors tab. 3. Click Add. A table appears, displaying a list of spectrum analysis devices, sorted by name. Single-radio spectrum devices have a single entry in this table, and dual-radio spectrum devices have two entries: one for each radio. This table displays the following data for each radio. Dell Networking W-Series ArubaOS 6.4.x | User Guide Spectrum Analysis | 780