Dell W-7030 AOS 6.4.x User Guide - Page 522

Table 103: ARM Profile Configuration Parameters Setting Description Mode Aware ARM If enabled, ARM will turn APs into Air Monitors (AMs) if it detects higher coverage levels than necessary. This helps avoid higher levels of interference on the WLAN. Although this setting is disabled by default, you may want to enable this feature if your APs are deployed in close proximity (less than 60 feet apart). Mode aware ARM turns Air Monitors back into APs when they detect gaps in coverage. Note that an Air Monitor will not turn back into an AP if it detects client traffic (or client traffic increases), but will change to an AP only if it detects coverage holes. Default: disabled Scan Mode By default, 802.11n-capable APs scan channels within all regulatory domains. To limit the AP scans to just the regulatory domain for that AP, click the Scan Mode drop-down list and select reg-domain. NOTE: This setting does not apply to APs that do not support 802.11n; these APs will scan their regulatory domain only. Video Aware Scan As long as there is at least one video frame every 100 mSec the AP will reject an ARM scanning request. Note that for each radio interface, video frames must be defined in one of two ways: l Classify the frame as video traffic via a session ACL. l Enable WMM on the WLAN's SSID profile and define a specific DSCP value as a video stream. Next, create a session ACL to tag the video traffic with the that DSCP value. In the CLI You must be in config mode to create, modify or delete an ARM profile using the CLI. Specify an existing ARM profile with the parameter to modify an existing ARM profile, or enter a new name to create an entirely new profile. Configuration details and any default values for each of these parameters are described in Table 103. If you do not specify a parameter for a new profile, that profile uses the default value for that parameter. Put the no option before any parameter to remove the current value for that parameter and return it to its default setting. The ARM profile includes advanced client match settings that can be configured through the command-line interface only. The default values for these settings are recommended for most users, and caution should be used when changing them to a non-default value. For complete details on all client match configuration settings, refer to the Dell Networking W-Series ArubaOS CLI Reference Guide. Use the following commands to create or modify an ARM profile: (host)(config) #rf arm-profile rf arm-profile 40MHz-allowed-bands {All|None|a-only|g-only} 80MHz support acceptable-coverage-index active-scan (not intended for use) assignment {disable|maintain|multi-band|single-band} backoff-time channel-quality-aware-arm channel-quality-threshold channel-quality-wait-time client-aware Dell Networking W-Series ArubaOS 6.4.x | User Guide Adaptive Radio Management | 522