Dell XPS 13 9310 Service Manual - Page 19

Removing the M.2 2280 solid-state drive, Steps, Next steps, Prerequisites

Get Dell XPS 13 9310 PDF manuals and user guides View all Dell XPS 13 9310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

NOTE: This procedure applies only if you are installing an M.2 2230 solid-state drive. The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure. Steps 1. Align the notch on the M.2 2230 solid-state drive with the tab on solid-state drive slot on the system board. 2. Slide the M.2 2230 solid-state drive into solid-state drive slot on the system board. 3. Insert the notch on the solid-state drive shield into a slot on the peg on the system board. 4. Replace the screw (M2x3) that secures the M.2 2230 solid-state drive shield to the system board. 5. Route the antenna cable through the routing guides along the solid-state drive shield. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. Removing the M.2 2280 solid-state drive Prerequisites 1. Follow the procedure in Before working inside your computer. CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive. Removing and installing components 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
NOTE:
This procedure applies only if you are installing an M.2 2230 solid-state drive.
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1.
Align the notch on the M.2 2230 solid-state drive with the tab on solid-state drive slot on the system board.
2.
Slide the M.2 2230 solid-state drive into solid-state drive slot on the system board.
3.
Insert the notch on the solid-state drive shield into a slot on the peg on the system board.
4.
Replace the screw (M2x3) that secures the M.2 2230 solid-state drive shield to the system board.
5.
Route the antenna cable through the routing guides along the solid-state drive shield.
Next steps
1.
Install the
base cover
.
2.
Follow the procedure in
After working inside your computer
.
Removing the M.2 2280 solid-state drive
Prerequisites
1.
Follow the procedure in
Before working inside your computer
.
CAUTION:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Removing and installing components
19