Dell XPS 13 9310 Service Manual - Page 20

Installing the M.2 2280 solid-state drive, To avoid data loss

Get Dell XPS 13 9310 PDF manuals and user guides View all Dell XPS 13 9310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

CAUTION: To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state. 2. Remove the base cover. About this task NOTE: Depending on the configuration ordered, your computer may support an M.2 2280 solid-state drive or an M.2 2280 solid-state drive. NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive. The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the removal procedure. Steps 1. Remove the antenna cable from the routing guides along the edge of the solid-state drive shield. 2. Remove the screw (M2x3) that secures the M.2 2280 solid-state drive shield to the system board. 3. Slide and lift the M.2 2280 solid-state drive off the solid-state drive slot on the system board. Installing the M.2 2280 solid-state drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. 20 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
CAUTION:
To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state.
2.
Remove the
base cover
.
About this task
NOTE:
Depending on the configuration ordered, your computer may support an M.2 2280 solid-state drive or an M.2 2280
solid-state drive.
NOTE:
This procedure applies only to computers shipped with an M.2 2280 solid-state drive.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1.
Remove the antenna cable from the routing guides along the edge of the solid-state drive shield.
2.
Remove the screw (M2x3) that secures the M.2 2280 solid-state drive shield to the system board.
3.
Slide and lift the M.2 2280 solid-state drive off the solid-state drive slot on the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
20
Removing and installing components