Dell XPS 13 9310 Service Manual - Page 27
Installing the heat-sink and fan assembly, About this task, Steps, Prerequisites
View all Dell XPS 13 9310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
About this task NOTE: This procedure applies to computers shipped with 11th Generation Intel Core i5-1135G7 processor or 11th Generation Intel Core i7-1165G7 processor. The heat sink and the fans are combined in a heat-sink and fan assembly. The following image indicates the location of the heat-sink and fan assembly and provides a visual representation of the removal procedure. Steps 1. In reverse sequential order (as indicated on the heat-sink and fan assembly), loosen the four captive screws (M2x3) that secure the heat-sink and fan assembly to the system board. 2. Peel the tapes that secure the fan cables to the system board. 3. Disconnect the fan cables from the system board. 4. Remove the four screws (M1.6x2.5) that secure the fans to the system board. 5. Lift the heat-sink and fan assembly off the system board. Installing the heat-sink and fan assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. NOTE: This procedure applies to computers shipped with 11th Generation Intel Core i5-1135G7 processor or 11th Generation Intel Core i7-1165G7 processor. The heat sink and the fans are combined in a heat-sink and fan assembly. CAUTION: Incorrect alignment of the heat-sink and fan assembly can damage the system board and processor. NOTE: If either the system board or the heat-sink and fan assembly is replaced, use the thermal pad/paste provided in the kit to ensure that thermal conductivity is achieved. About this task The following image indicates the location of the heat-sink and fan assembly and provides a visual representation of the installation procedure. Removing and installing components 27