Dell XPS 13 9365 2-in-1 XPS 13 Convertible Service Manual - Page 16

Replacing the solid-state drive, Procedure, Post-requisites

Get Dell XPS 13 9365 2-in-1 PDF manuals and user guides View all Dell XPS 13 9365 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

8 Replacing the solid-state drive NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive. Topics: • Procedure • Post-requisites Procedure 1. Align the notches on the solid-state drive with the tabs in the solid-state drive slot, slide the solid-state drive at an angle into the solidstate drive slot, then press the other end of the solid-state drive down. 2. Align the screw holes on the hard disk plate with the screw holes on the system board. 3. Replace the two screws (M1.6x2.5) that secure the hard-disk plate to the system board. 4. Adhere the display-cable tape to the hard-disk plate. Post-requisites 1. Replace the battery. 2. Replace the base cover. 16 Replacing the solid-state drive

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
Replacing the solid-state drive
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
After
working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
.
CAUTION:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
•
Procedure
•
Post-requisites
Procedure
1.
Align the notches on the solid-state drive with the tabs in the solid-state drive slot, slide the solid-state drive at an angle into the solid-
state drive slot, then press the other end of the solid-state drive down.
2.
Align the screw holes on the hard disk plate with the screw holes on the system board.
3.
Replace the two screws (M1.6x2.5) that secure the hard-disk plate to the system board.
4.
Adhere the display-cable tape to the hard-disk plate.
Post-requisites
1.
Replace the
battery
.
2.
Replace the
base cover
.
8
16
Replacing the solid-state drive