Denon D-F101S Owners Manual - Page 5

ENGLISH 2 BEFORE USING Read the following before using the set. • Before turning on the power Check again that all connections are correct and that there are no problems with the connection cords. Be sure to unplug the power cord before connecting or disconnecting the connection cords. • Moving the set To prevent short-circuits or damage to the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the set. • Store this instructions in safe place After reading, store this instructions along with the warranty in a safe place. Also fill in the items on the back paper for your convenience. • Illustrations in this manual Note that some of the illustrations used for explanations in this manual may differ from the actual set. 3 CONNECTING THE ANTENNAS Installing the FM indoor antenna Tune in FM station (see page 13), set the antenna so that distortion and noise is minimal, then secure the tip of the antenna in this position using tape or a pin. Installing the AM loop antenna Tune in an AM station (see page 13) and set the antenna as far from the system as possible to keep distortion and noise is minimal. In some cases, it is best to invert the polarities. AM broadcasts cannot be received well if the loop antenna is not connected or if it is set close to metal objects. AM loop antenna Assembling the AM loop antenna Installing an AM outdoor antenna Connect the signal wire from the AM outdoor antenna to the antenna terminal. Be sure to connect the signal ground wire to the terminal. Also be sure to connect the included AM loop antenna. AM LOOP ANT. ANTENNA Connecting an FM outdoor antenna If good reception cannot be achieved with the included FM antenna, use an FM outdoor antenna. Connect an IECtype connector to the coaxial cable and connect the antenna to the FM COAX (75 Ω/ohms) terminal. Selecting a place for the FM outdoor antenna • Set the antenna so that it points towards the broadcast station's transmitting antenna. Behind buildings or mountains, set the antenna in the position at which reception is best, and also try changing the direction of the antenna. • Do not install the antenna under power lines. Doing so is extremely dangerous, as the power line could touch the antenna. • Install the antenna away from roads or train tracks to avoid noise from cars or trains. • Do not install the antenna too high, as it may be hit by lightning. AM loop antenna AM outdoor antenna Signal ground 1 2 Connect to the AM antenna terminals. 3 FM antenna FM COAX. 75 AM LOOP ANT. ANTENNA Remove the vinyl tie and take out the connection line. 4 a. With the antenna on top any stable surface. Mount b. With the antenna attached to a wall. Bend in the reverse direction. Installation hole Mount on wall, etc. 5