Denon D-F101S Owners Manual - Page 7

ENGLISH System Operations • System operations such as the timer playback and auto power on functions can only be used if stereo audio cords and system cords are connected between all the system components. Be sure to securely connect all the connection cords between all the units. • Disconnecting a system cord during system operation may result in malfunction. Be sure to unplug the power cords before changing the connections. 2 Recommended System Installation • To ensure performance and stability, install the system (D-F101 series) as shown below. (DRA-F101) FUNCTION TONE SYSTEM ON / STANDBY PHONES TIMER DISPLAY MEMORY / SET TUNING DOWN UP BAND SOURCE DIRECT VOLUME AM-FM STEREO RECEIVER DRA-F101 (DCD-F101) ON / STANDBY TRACK REPEAT COMPACT DISC PLAYER DCD-F101 ✽ Do not place another component directly on top of the DRA-F101. To allow for heat dispersal, leave a space of at least 10 cm above the DRA-F101 so as not to obstruct its ventilation holes. ✽ For stability, do not stack more than three components on top of each other. For heat dispersal, leave at least 10 cm of space between the top, back and sides of this unit and the wall or other components. Connecting Speaker Systems 2 Speaker impedance Use speaker systems with an impedance of 4 to 16Ω/ohms. • Note that using speakers with other impedances will activate the protector circuit and may result in damage. 2 Connecting the speaker cords q Peal off the coating from the tip of the cord. w Twist the core wire. e Turn the speaker terminal counterclockwise to loosen it. r Completely insert the core wire, then turn the terminal clockwise to tighten it. Protector Circuit qw er The DRA-F101 is equipped with a high speed protector circuit. This circuit prevents strong currents from being generating inside the unit and damaging internal circuitry if the speaker cables are not securely connected to the speaker terminals or if they are short-circuited. If the protector circuit is activated, the speaker output is automatically cut off. If this happens, turn off the unit's power, check the speaker cable connections, then turn the power back on. The sound will be muted for several seconds, after which the unit will operate normally. B Be sure to connect the speaker cords to the terminals with the same polarities on the speaker and amplifier ( < to to > ). B When connecting, make sure that the speaker cords' core wires do not stick out and touch other terminals, other core wires or the rear panel. NOTE: • NEVER touch the speaker terminals while the set is connected to a power supply. Doing so may result in electric shock. ✽ ✽ 10 cm or more FUNCTION TONE SYSTEM ON / STANDBY PHONES TIMER DISPLAY MEMORY / SET TUNING DOWN UP BAND SOURCE DIRECT VOLUME ✽ AM-FM STEREO RECEIVER DRA-F101 5 cm ✽ ✽ • Switching the input function when input jacks are not connected A clicking noise may be produced if the input function is switched when nothing is connected to the input jacks. If this happens, either turn down the VOLUME control or connect components to the input jacks. Please be sure to unplug the cord when you leave home for a vacation. 7