Dewalt DXCMH1393075 Instruction Manual - Page 28
Adjusting, Tension, Motor Pulley/Flywheel Alignment, Pump Oil
![]() |
View all Dewalt DXCMH1393075 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English CODE POSSIBLE CAUSE 14 Engine mounting bolts are loose 15 Pump stabilizer bracket bolts are loose 16 Loose pulley 17 Loose flywheel 18 Carbon build-up in pump 19 Belt to tight 20 Pulley misalignment 21 Engine problem 22 Engine or pump oil is low POSSIBLE SOLUTION Tighten mounting screws. Torque engine mounting bolts to 15- 22 ft‑lbs (20.3- 29.8 Nm). WARNING: Risk of bursting. Excessive vibration could weaken the air tank and cause it to rupture or explode. Mounting screws must be kept tightened. Check bolt and tighten if required. Torque pump stabilizer bracket bolt to 15- 22 ft‑lbs (20.3-29.8 Nm). WARNING: Risk of bursting. Excessive vibration could weaken the air tank and cause it to rupture or explode. Stabilizer bracket bolt must be kept tightened. Never operate the unit unless equipped with the stabilizer bracket. Tighten pulley set screw, torque to 145-180 in.-lbs. (16.4- 20.3 Nm). Tighten flywheel screw, torque to 15-18 ft.-lbs. (20.3-24.4 Nm). Contact a DeWALT factory service center or a DeWALT authorized service center. Check belt tension, see Adjusting Belt Tension under Maintenance. See Motor Pulley/Flywheel Alignment under Maintenance. Contact a DeWALT factory service center or a DeWALT authorized service center. Add DeWALT synthetic compressor oil to pump. See Compressor Pump Oil under Maintenance. 28
![](/manual_guide/products/dewalt-dxcmh1393075-instruction-manual-21a4dff/28.png)