Dewalt DXCMH1393075 Instruction Manual - Page 6

English • Exposure to chemicals in dust created by power sanding, sawing, grinding, drilling and other construction activities may be harmful. • Sprayed materials such as paint, paint solvents, paint remover, insecticides, weed killers, may contain harmful vapors and poisons. • Work in an area with good cross ventilation. Read and follow the safety instructions provided on the label or safety data sheets for the materials you are spraying. Always use certified safety equipment: NIOSH/OSHA respiratory protection or properly fit­ting face mask designed for use with your specific application. DANGER: RISK OF BURSTING Air Tank: On February 26, 2002, the U.S. Consumer Product Safety Commission published Release # 02-108 concerning air compressor tank safety: Air compressor receiver tanks do not have an infinite life. Tank life is dependent upon several factors, some of which include operating conditions, ambient conditions, proper installations, field modifications, and the level of maintenance. The exact effect of these factors on air receiver life is difficult to predict. If proper maintenance procedures are not followed, internal corrosion to the inner wall of the air receiver tank can cause the air tank to unexpectedly rupture allowing pressurized air to suddenly and forcefully escape, posing risk of injury to consumers. Your compressor air tank must be removed from service by the end of the year shown on your tank warning label. The following conditions could lead to a weakening of the air tank, and result in a violent air tank explosion: WHAT CAN HAPPEN • Failure to properly drain condensed water from air tank, causing rust and thinning of the steel air tank. HOW TO PREVENT IT • Drain air tank daily or after each use. If air tank develops a leak, replace it immediately with a new air tank or replace the entire compressor. • Modifications or attempted repairs to the air tank. • Never drill into, weld or make any modifications to the air tank or its attachments. Never attempt to repair a damaged or leaking air tank. Replace with a new air tank. • Unauthorized modifications to the unloader valve, safety valve, or any other components which control air tank pressure. • The air tank is designed to withstand specific operating pressures. Never make adjustments or parts substitutions to alter the factory set operating pressures. • Excessive vibration can • Do not remove the stiffener bar weaken the air tank and connecting the compressor cause rupture or explosion. pump to the engine, except Excessive vibration will occur if to adjust belt tension. Then the compressor is not properly securely tighten the stiffener mounted or if engine operates bar bolts. This bar controls unit above recommended RPM. vibration. 6