Electrolux ERFC2393AS Complete Owners Guide - Page 17

17 WATER SUPPLY CONNECTION 4. If you use copper tubing - Slide the brass compression nut, then ferrule (sleeve) onto the water supply line. Push the water supply line into water valve inlet as far as it will go (¼ inch/6.4 mm). Slide ferrule (sleeve) into the valve inlet and finger tighten the compression nut onto valve. Tighten another half turn with a wrench; DO NOT over tighten. See Figure 1. • If you use braided flexible stainless steel tubing - The nut is already assembled on the tubing. Slide the nut onto the valve inlet and finger tighten the nut onto valve. Tighten another half turn with a wrench; DO NOT over tighten. See Figure 2. 5. Using the steel clamp and screw, secure water supply line to rear panel of refrigerator as shown. 6. Coil excess water supply line (copper tubing only), about 2½ turns, behind the refrigerator as shown and arrange coils so they do not vibrate or wear against any other surface. Do not kink tubing. 7. Turn ON the water supply at the shutoff valve and tighten any connections that leak. 8. Reconnect refrigerator to electrical power source. 9. To turn ice maker on, ensure the Ice Maker is enabled on display (LED will be lit) or set the ice maker's On/ off power switch to the "ON" position (freezer ice maker).  NOTE These instructions do not cover after market ice maker installation. Instructions in after market ice maker kit should be used. Steel Clamp Brass Compression Nut Ferrule (Sleeve) Copper Water line Water Valve Bracket Valve Inlet Water Valve Copper waterline from household water supply (Include enough tubing in loop to allow moving refrigerator out for cleaning) Figure 1 IMPORTANT Your refrigerator's water supply system includes several tubing lines, a water filter, and a water valve. To ensure that your water dispenser works properly, this system must be completely filled with water when your refrigerator is first connected to the household water supply line. (Include enough tubing in loop to allow moving refrigerator out for cleaning) Steel Clamp Braided Flexible Stainless Steel Water Line Valve Inlet Water Valve 6 ft. (1.8 Meters) Braided flexible stainless steel water line from household water supply. Figure 2