Electrolux ERFC2393AS Complete Owners Guide - Page 36
Ordering Replacement Filters, Replacing the, Water Filter, More about your Advanced
View all Electrolux ERFC2393AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
36 FILTER REPLACEMENT Replacing the Water Filter More about your Advanced Water Filter The water filter is located at the bottom left of the refrigerator compartment next to the Adjustable Temp Drawer. In general, you should change the water filter every 6 months to ensure the highest possible water quality. Water Filter Status on the user interface prompts you to replace the filter after a standard amount of water (125 gal/453 L for PureAdvantage™) has flowed through the system. If you have not used your refrigerator for a period of time (during moving for example), change the filter before reinstalling the refrigerator. The PureAdvantage™ ice and water filter system is tested and certified to NSF/ANSI Standards 42, 53, 401 and CSA B483.1 for the reduction of claims specified on the performance data sheet. Visit electrolux.com for more information. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Use systems certified for cyst reduction on disinfected waters that may contain filterable cysts. Test & certification results: Ordering Replacement Filters • Rated Capacity - 125 gal/453 L for PureAdvantage™ and ice and water filter To order your replacement filters, please visit our online store at electrolux.com, by calling toll-free at 1 (877) 435-3287, or by visiting the dealer where you purchased your refrigerator. Electrolux recommends that you order extra filters when you first install your refrigerator, and that you replace your filters at least once every 6 months. Here are the product numbers to request when ordering: PureAdvantage™ Water Filter PWF-1 Part# EPPWFU01™ • Rated service flow - .50 gal/min. • Operating Temp.: Min. 33°F, Max. 100°F • Maximum Rated Pressure - 100 lbs/in.² • Recommended Minimum Operating Pressure: 30 lbs/in² Replacing your PureAdvantage™ water filter It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. NOTE When you order your replacement filter, please reorder the same filter type currently in your refrigerator. 1. Turn Off the ice maker(s). 2. Remove the filter by pushing on the end/face of the filter. 3. Slide the old water filter cartridge straight out of the housing and discard it. 4. Remove the new filter cartridge from the package. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.