Epson 7900p Product Information Guide - Page 15

Epson PowerLite 7900p Projector Setting Up the Network Connect each projector you want to monitor to your network and configure it with an appropriate IP address. 1. Connect the projector to your network using a commercially available 100baseTX or 10baseT network cable. Plug the cable into the projector's Ethernet port. Ethernet port To network port 2. Turn on the projector. 3. Press the Menu button on the remote control and select Network from the Advanced2 menu. Video Audio Effect Setting User's Logo Advanced1 Advanced2 About Reset All Brightness Control : High Low Projector ID : 1 Set Network Set COM Port : RS-232C USB Auto setup : ON OFF BNC Sync Termination : ON OFF Reset Execute Select Network [ ]: Select [ ]: Enter [Menu]: Exit 4. If your network assigns addresses automatically, turn on DHCP. 5. If your network does not assign addresses automatically, turn off DHCP and enter the projector's IP Address, Subnet Mask, and Gateway Address, as needed. ❏ To enter numbers using the remote control, press the Num button until it lights, then use the numeric keypad. ❏ To change the network addresses from the projector's control panel, press the right and left arrow buttons to select the part of the address you want to enter, then use the up and down arrow buttons to increase or decrease the numeric value. Increase or decrease the value Select the part of the address to change Note: If you're a network administrator, you can use the SNMP option to enter a trap IP address. This lets you receive trap alerts for the projectors you're monitoring. If you have HP OpenView, a plug-in is available to allow you to manage your projectors in HP OpenView. Check with your dealer or Epson. When you finish changing an address in the network menu, press the Enter button (on the remote control) or the Auto/Enter button (on the projector). This stores the value. 6. When you're done making all necessary changes, press ESC to exit the menu system. Opening and Closing EMP Monitor To start EMP Monitor, click Start > Programs or All Programs > Epson Projector > EMP Monitor. If you've added the program to the Startup programs folder, it may already be open. If so, click the icon in the system tray on the lower-right corner of your screen to display the EMP Monitor window: Click here to start EMP Monitor To close EMP Monitor, right-click the program icon shown above, then select Exit. Num button Zero 9/04 Epson PowerLite 7900p Projector - 15