Epson 7900p Product Information Guide - Page 22
Resetting the Lamp Timer, Transporting the Projector
UPC - 010343852464
View all Epson 7900p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Epson PowerLite 7900p Projector 6. To remove the lamp cover, insert the screwdriver supplied with the spare lamp (or another flat-tipped screwdriver), into the space beside the air vent to gently lift the lamp cover off. Insert the screwdriver here 1 7. Loosen the two screws holding the lamp in place. (You don't need to remove them.) Resetting the Lamp Timer After you replace the lamp, you need to reset the lamp timer using the projector's About menu. 1. Press the Menu button on the remote control or the projector's control panel to display the main menu. 2. Use the pointer button on the remote control (or the arrow buttons on the projector) to highlight About, then press Enter. You see this screen: Video Audio Effect Setting User's Logo Advanced1 Advanced2 About Reset All Lamp : 1400H Reset Lamp Timer Execute Video Source Input Signal : Computer1 : Analog-RGB Frequency : H ---.---kHz V ---.---Hz SYNC Polarity : H -----V ------ SYNC Mode Resolution Refresh Rate x Hz Lamp usage [ ]: Select [ ]: Enter [Menu]: Exit Note: The lamp usage timer shows 0H until you've used the lamp for at least 10 hours. 3. Select Reset Lamp Timer. You see this prompt: 8. Grasp the wire handle as shown and pull the lamp straight out. 9. Gently insert the new lamp. 10. Once the lamp is fully inserted, tighten its screws and replace the cover. (The projector won't come on if the lamp cover is loose.) 11. Reset the lamp timer as described in the next section. 4. Select Yes. 5. When you're finished, press ESC or Menu to exit. Transporting the Projector The projector contains many glass and precision parts. Follow these guidelines to prevent injury or damage when transporting it: ❏ When hand-carrying the projector, you should use the handle to carry it only a short distance (for example, to set it on a table). ❏ When shipping the projector for repairs, use the original packaging material if possible. If you do not have the original packaging, use equivalent materials, placing plenty of cushioning around the projector. ❏ When transporting the projector a long distance, first place it in a hard-shell shipping case, and then pack it in a firm box, placing cushioning around the case. (An optional ATA shipping case is available from Epson; see the following table.) 22 - Epson PowerLite 7900p Projector 9/04