Epson ActionTower 8000 User Manual - Page 122
and the, Tower Computer
View all Epson ActionTower 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
4. Position the IDE device cable so the side with the red wire aligns with pin 1 on the drive. Make sure the holes in the connector fit over all the pins; then push in the connector. 5. Locate one of the power supply cables that lead from the power supply. (They have multi-colored wires and a plastic connector on the end.) Align the notched comers of the power supply connector and the drive's power connector; then push in the connector, as shown above. Note Your system has five power supply cables; three with large connectors and two with small connectors. If you need more than five cables, you can purchase Y-adapters at most computer accessory stores. Y-adapters let you use one power supply cable for two devices. 6. If you have finished installing or removing drives, replace the computer's cover; see "Replacing the Cover" in Chapter 4 for instructions. Then see "Running SETUP" in Chapter 2 for instructions on defining your new drive configuration. Installing and Removing Drives in the Tower Computer 6-7