Epson ActionTower 8000 User Manual - Page 26
Connecting the Power Cord
View all Epson ActionTower 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
You may also need to change the setting of the LPT Port option in SETUP if you need a different address and /or interrupt assignment for the port. Note If you use ECP (Extended Capabilities Port) mode, you máy also need to change jumpers JP8 and JP9 to the correct DMA channel; check your parallel device documentation for the DMA channel you should use. Then see "Changing the Jumper Settings" in Chapter 4 for instructions on setting jumpers. Using the serial ports If you have a printer, a modem, or other device with a serial interface, you can connect it to one of the serial (RS-232C) ports. Make sure you have a cable compatible with a DE-9P connector. To connect a serial device, insert the connector into either the serial 1 or serial 2 port. If you are connecting only one serial device, use the serial 1 port. Connecting the Power Cord Follow these steps to connect the computer's power cord: 1. Plug the power cord into the power inlet on the back of the computer. voltage hector witch 1-8 Setting Up Your System