Epson DS-560 WorkForce DS-560 User Manual - Page 38
Using WPS to Connect to a Network, Parent topic, Wi-Fi, Connect, Status
View all Epson DS-560 WorkForce DS-560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access point. If there is no hardware button, there may be a virtual WPS button in the software for the device. Check your network product documentation for details. Using WPS to Connect to a Network Using WPS PIN Mode to Connect to a Network Parent topic: Wi-Fi Networking Using WPS to Connect to a Network If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network. 1. Set the connection mode on the scanner to Wi-Fi. 2. Open the input tray and turn on the scanner. 3. Press and hold the Connect button for at least 3 seconds until the Status and ! error lights flash alternately. The scanner enters standby status for WPS connection for two minutes. 38