Epson ET-2850U for ReadyPrint Users Guide - Page 254
product's radio waves from affecting the operation of the pacemaker.
View all Epson ET-2850U for ReadyPrint manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
• If you use an extension cord with the product, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. • Always turn off the product using the power button, and wait until the power light stops flashing before unplugging the product or cutting off power to the electrical outlet. • If you will not be using the product for a long period, unplug the power cord from the electrical outlet. • Place the product on a flat, stable surface that extends beyond its base in all directions. It will not operate properly if it is tilted or at an angle. • Allow space behind the product for the cables, and space above the product so that you can fully raise the document cover. • Leave enough space in front of the product for the paper to be fully ejected. • Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust. • Do not place or store the product outdoors. • Do not place the product near excessive heat sources or in direct sunlight. • Leave enough room around the product for sufficient ventilation. Do not block or cover openings in the case or insert objects through the slots. • Keep the product away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones. • Keep your product at least 8.7 inches (22 cm) away from cardiac pacemakers to prevent your product's radio waves from affecting the operation of the pacemaker. • When connecting the product to a computer or other device with a cable, ensure the correct orientation of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation may damage both devices connected by the cable. • Do not sit or lean on the product. Do not place heavy objects on the product. • Do not touch the flat white cable, translucent film, or ink tubes inside the product. • Do not move the print head by hand; this may damage the product. • Do not put your hand inside the product while it is printing. • Do not spill liquid on the product or use the product with wet hands. • Do not use aerosol products that contain flammable gases inside or around the product. Doing so may cause fire. • Do not press too hard on the scanner glass when placing originals. 254