Epson Ensemble HD 8100 Installation Guide - Page 27
connector unconnected for now it will go to the projector.
View all Epson Ensemble HD 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
4 Connect one end of the Control Cable to the control port, as shown below. To AV controller (do not connect yet) 5 Connect the individual connectors of the Speaker Cable to the corresponding connectors inside the screen. Match up the L (Left), C (Center), and R (Right) labels on the connectors. Leave the 4-pin connector unconnected for now (it will go to the projector). To subwoofer (do not connect yet) Cables inside screen Do not connect yet 6 Place one end of the Video Cable near the middle of the screen. You will connect it later. To AV controller (do not connect yet) Place connector near middle of screen 7 Locate AC CABLE 3 (Y-shaped cable), which is packed in the AC power cable box inside box #5 with the subwoofer. Note Let the loose ends of the cables connected in the following steps hang out from the middle of the screen. You will connect them later. 27