Epson Ensemble HD 8100 Installation Guide - Page 56
Adjusting the Projector Settings, If the projector is installed above 4900 feet 1500 meters, turn
View all Epson Ensemble HD 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Adjusting the Projector Settings Use the projector's remote control to adjust the following settings. Note If you need to restore the projector's factory settings, open the Reset menu and select Reset All. 1 Press the HDMI button on the remote control to select HDMI as the source. 2 Press the Menu button on the remote control. You see the main menu screen: Projector remote control 3 Open the Settings menu (press the d button to highlight Settings, then press Select). 4 To invert the image, press the d button to highlight Projection, then press the Select button. Select Front/Ceiling, then press . The image is inverted. Press the Esc button to return to the Settings menu. 5 If the projector is installed above 4900 feet (1500 meters), turn on High Altitude Mode so the fan can properly cool the projector. Press the Esc button to return to the Settings menu. 6 Highlight Display and press . For the Startup Screen setting, select Off. Press the Esc button twice to return to the main menu. 7 Open the Signal menu and set Output Scaling to 100%. Note To adjust this setting, the AV controller must be turned on so that the projector is receiving a signal. 8 Press the Esc button as needed to exit the menu system. 56