Epson LQ-1010 User Manual - Page 242
Initialization, Default Settings, Technical Specifications
View all Epson LQ-1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
Initialization There are two ways that the printer can be initialized (returned to the default settings) through the hardware and one way through the software. These are described in the following table: Hardware initialization Software initialization l The power is turned on. l The printer receives an INIT signal at the parallel interface (pin 31 goes LOW). l The software sends the ESC @ (initialize the minter) command. Default Settings The table below shows the default conditions that become valid when the printer is initialized. Item Top of form position Left and right margins Line spacing Vertical tab position Horizontal tab positions VFU channel Font selection Condensed mode Character spacing Justification Special printing effects Graphic mode assignment Reset to: Current paper position Cancelled 1/6-inch line spacing Cleared Every eight characters Channel 0 Hardware: The current DIP switch setting Software: The current SelecType setting Hardware: The current DIP switch setting Software: The current SelecType setting The current DIP switch setting Left justification Cancelled (except condensed printing) ESC K = ESC * 0, ESC L = ESC * 1, ESC Y = ESC * 2, ESC Z = ESC * 3 8-14 Technical Specifications