Epson Personal Document Station User Setup Information - PC - Page 6
°1
 |
View all Epson Personal Document Station manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Carefully remove the interface board from its packaging, holding it only by its top edges. Then place it on a flat, clean surface. Caution: Avoid touching the components or the gold contacts on the interface board; they can be damaged by static electricity. Locate jumpers J1 and J2 on the interface board, as shown below. IRQ5 IRO7 123 J2 7 GJ"- 0 00O00 01°1 0 000 The settings are printed on the circuit board next to the jumpers. To change a setting, lift off the jumper cap and reinstall it over the appropriate pair of pins. Caution: Be careful not to bend the jumper pins. 4 Getting Started
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
-
17
-
18
 |
 |
Carefully remove the interface board from its packaging,
holding it only by its top edges. Then place it on a flat,
clean surface.
Caution:
Avoid touching the components or the gold contacts on the
interface board; they can be damaged by static electricity.
Locate jumpers J1 and J2 on the interface board, as shown
below.
IRQ5
IRO7
1
2
3
J2
7
GJ”-
O0
0 000
01°1
0 000
The settings are printed on the circuit board next to the
jumpers. To change a setting, lift off the jumper cap and
reinstall it over the appropriate pair of pins.
Caution:
Be careful not to bend the jumper pins.
4 Getting Started