Epson SureLab D3000 - Single Roll User Manual - Page 41
the light flashes to indicate the current paper type.
![]() |
View all Epson SureLab D3000 - Single Roll manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Replacing Paper H Slide the right Paper width guide to the left until it is flush with the edge of the paper. Note: O Make sure that there is no gap between the Paper width guide and the edge of the paper. If there is a gap, the print position may be misaligned, or a feeding error may occur. O Do not push the Paper width guide against the paper too forcefully. The paper may be damaged, or it may cause a paper jam. I If the paper type has changed, set the paper type on the Operation panel. Each time you press the Paper type setting switch on the rear roll paper feeder, the paper type changes and the light flashes to indicate the current paper type. Tip: If you clear the cover open error by clicking OK on the Client PC, you cannot change the paper type. To change the paper type, remove the paper from the Paper feed slot, reinsert it, and then try again. 41
![](/manual_guide/products/epson-surelab-d3000-double-roll-561f18f/41.png)