Epson SureLab D700 Operation Guide - Page 75

Troubleshooting Code W-1305 I-1311 W-1101 W-1102 W-1103 W-1104 W-1105 W-1106 W-1107 W-1108 Message Rear cover open. Delete all print jobs remaining in the operating sytem's print queue. Close the rear cover. Check the scrap paper box. Empty the box if it is full. A paper jam has occurred. Delete all print jobs remaining in the operating sytem's print queue. Remove any paper remaining from the roll paper feeder, and then reload the paper. A paper jam has occurred. Delete all print jobs remaining in the operating sytem's print queue. Open the rear cover and the top cover, remove any paper remaining, and then reload the paper. An error has occurred in the paper feeding unit. Delete all print jobs remaining in the operating sytem's print queue. Reload the paper in the same way as when replacing paper. Paper is not loaded correctly. Delete all print jobs remaining in the operating sytem's print queue. Check the positions of the edge guides, and then reload the paper. Paper is out. Delete all print jobs remaining in the operating system's print queue. Load paper. Paper is out or not loaded correctly. Delete all print jobs remaining in the operating system's print queue. Load paper. The loaded paper does not match the print settings. Delete all print jobs remaining in the operating system's print queue. After deleting the print jobs, change the print settings or the loaded paper, and then print. If you click [OK] without deleting the print jobs, the jobs are printed using the current settings. The width of the loaded paper is not supported. Delete all print jobs remaining in the operating system's print queue. Load supported paper. What to do Close the rear cover. Check the scrap paper box, and empty it if it is full. See "Emptying the Scrap Paper Box" on page 56. Remove the paper from the roll paper feeder, and then reload the paper. See "Paper Jams" on page 79. Remove the paper from the internal paper feeder, and then reload the paper. See "Paper Jams" on page 79. Check that there is no paper inside the printer, and then reload the paper. See "Replacing Paper" on page 23. Check that there is no paper inside the printer, and then reload the paper. When loading the paper, match the inner edge guide and the front edge guide to the width of the paper. If a message is displayed, check the details. See "Replacing Paper" on page 23. After deleting all of the print jobs, check that there is no paper inside the printer, and then reload the paper. If a message is displayed, check the details. See "Replacing Paper" on page 23. After deleting all of the print jobs, load the appropriate paper. When replacing the paper, set the Paper Type and the Paper Level in the Maintenance Tool. See "Replacing Paper" on page 23. Load the appropriate paper. See "Replacing Paper" on page 23. 75