Epson V11H128020 User Manual - Page 57

Replacing the lamp, Remove the old lamp.

Get Epson V11H128020 - PowerLite S1 SVGA LCD Projector PDF manuals and user guides
UPC - 010343847408
View all Epson V11H128020 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 57 highlights

Projector Care 57 Replacing the lamp c • Wait until the lamp has cooled down sufficiently before opening the lamp cover. It takes one hour after the projector's cool-down period has finished for the lamp to be cool enough. • When the lamp is broken, replace it with a new lamp, or contact your dealer for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass. 1 Turn off the projector and wait for the cool-down period to end. (Approximately 20 seconds) 2 Unplug the power cable and remove it, then wait for the lamp to cool down. (Approximately 1 hour) 4 Loosen the screws holding the lamp in place. 5 Remove the old lamp. 3 Open the lamp cover. Push in the tabs on the lamp cover and push it up to remove it. 6 Install the new lamp. Press the lamp until it clicks into place, then tighten the two screws.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
57
Projector Care
Replacing the lamp
1
Turn off the projector and wait for the cool-down period to end.
(Approximately 20 seconds)
2
Unplug the power cable and remove it, then wait for the lamp to
cool down. (Approximately 1 hour)
3
Open the lamp cover.
Push in the tabs on the lamp cover and push it up to remove it.
4
Loosen the screws holding the lamp in place.
5
Remove the old lamp.
6
Install the new lamp.
Press the lamp until it clicks into place, then tighten the two screws.
c
• Wait until the lamp has cooled down sufficiently before opening the
lamp cover. It takes one hour after the projector’s cool-down period has
finished for the lamp to be cool enough.
• When the lamp is broken, replace it with a new lamp, or contact your
dealer for further advice. If replacing the lamp yourself, be careful to
avoid pieces of broken glass.