Fujitsu S510 Getting Started Guide - Page 8
Preparation - software
UPC - 097564307218
View all Fujitsu S510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
1. Preparation This chapter describes necessary preparations before using ScanSnap. Do not connect the scanner to your PC before installing "ScanSnap Manager". If the scanner is connected before installing ScanSnap Manager, it will not operate correctly. Refer to Chapter 2 for the installation of ScanSnap Manager. 1.1. Checking the Contents of the Package When you unpack the scanner package, make sure that all parts are included. Refer to the package contents list included in the scanner package box. 1.2. Names and Functions of Parts This section describes the names and functions of parts. Front View Paper chute Open this cover when using the scanner. Opening the cover turns ON the scanner. Cover open lever Pull this lever to open the ADF cover. Paper chute Open it and load the documents onto this part when scanning documents. Side guide Adjust these guides to the documents width for preventing skewed ADF (ADF: Automatic Document Feeder) Operation Buttons SCAN POWER Rear View USB connector [SCAN] button Starts scanning. [POWER] button Turns on/off the power supply. Power Indicator Indicates the scanner status of the power supply to the scanner. Blue (Solid): Ready Blue (Blinking): Scanning Orange: Error Light off: Power off AC adapter connector Seal (reminds you that the supplied software has to be installed first): After installing ScanSnap Manager onto your computer, remove this seal to connect the scanner to the PC. Security cable slot Plug a commercially available security cable into this slot (anti-theft) For the Document Specification, refer to the HINT "ScanSnap S510 Operator's Guide" stored in ScanSnap Setup CD-ROM. The scanner is turned on/off automatically, when you open/close the Paper chute cover. To turn off the scanner when the cover is opened, press the [POWER] button. Stacker For using this part, pull it out as shown in the figure. Operation Buttons Documents are ejected from the ADF onto this tray. 6