Garmin G600 Pilots Guide - Page 147

Foreword 4.3.5 TIS System Status The GDU 620 performs an automatic test of TIS during power-up. If TIS passes the test, TIS enters Standby Mode on the ground or Operating Mode in the air. If TIS fails the power up test, an annunciation is shown in the center of the Traffic Map Page. Sec 1 System Sec 2 PFD Sec 3 MFD Traffic Map Page Annunciation NO DATA* DATA FAILED* Description Data is not being received from the transponder Data is being received from the transponder, but a failure is detected in the data stream FAILED* The transponder has failed UNAVAILABLE TIS is unavailable or out of range * Contact a service center or Garmin dealer for corrective action Table 4-8 TIS Failure Annunciations Sec 4 Hazard Avoidance Features Sec 5 Additional Sec 6 Annun. & Alerts The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the ground, TIS automatically enters Standby Mode. If traffic is selected for display on another map while Standby Mode is selected, the traffic display enabled icon is crossed out (also the case when TIS has failed). Once the aircraft is airborne, TIS switches to Operating Mode and traffic information is displayed. The mode can be changed manually using soft keys or the page menu. Sec 7 Symbols Sec 8 Glossary Appendix A Mode Traffic Mode Annunciation Traffic Display Enabled Icon (Traffic Map Page) (Other Maps) TIS Operating OPERATING TIS Standby STANDBY (Also shown in white in center of page) TIS Failed* FAIL Appendix B Index Table 4-9 TIS Modes 190-00601-02 Rev. B Garmin G600 Pilot's Guide 4-21