Haier HMV1630DBWW HMV1630 Installation Guide - Page 17

Engglliisshh A5. MOUNT THE MICROWAVE OVEN 1. Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. 2. Rotate front of oven up against cabinet bottom. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 3. Insert a self-aligning screw through top 1 center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when 2 mounting flush to bottom of cabinet. 4. Attach the microwave oven to the top cabinet. 5. Insert 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess 6. Tighten center screw completely. Self-Aligning Screw 5 Microwave Oven Top 6 7. Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) 8. Install grease filters. See the Owner's Manual packed with the microwave. A6. ADJUST THE EXHAUST ADAPTOR Blower Plate Open the top cabinet and adjust the exhaust adaptor to connect to the house duct. A7. CONNECTING DUCTWORK 1. Extend the house duct down to connect to the exhaust adaptor. 2. Seal exhaust duct joints using duct tape. Damper Back of Microwave For Front-to-Back or Side-to-Side Adjustment, Slide the Exhaust Adaptor as Needed House Duct 16