Harbor Freight Tools 62779 User Manual - Page 56
For technical questions, please call 1-888-866-5797., Air Filter Element Maintenance, Cleaning,
![]() |
View all Harbor Freight Tools 62779 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Safety Air Filter Element Maintenance 1. Remove the air filter cover and the air filter elements and check for dirt. Clean as described below. 2. Cleaning: • For "paper" filter elements: To prevent injury from dust and debris, wear ANSI-approved safety goggles, NIOSH‑approved dust mask/respirator, and heavy-duty work gloves. In a well-ventilated area away from bystanders, use pressurized air to blow dust out of the air filter. If this does not get the filter clean, replace it. • For foam filter elements: Wash the element in warm water and mild detergent several times. Rinse. Squeeze out excess water and allow it to dry completely. Soak the filter in lightweight oil briefly, then squeeze out the excess oil. 3. Install the cleaned filter. Secure the Air Cleaner Cover before use. Spark Plug Maintenance Spark Plug Cap 1. Disconnect spark plug cap from end of plug. Clean out debris from around spark plug. 2. Using a spark plug wrench, remove the spark plug. 3. Inspect the spark plug: If the electrode is oily, clean it using a clean, dry rag. If the electrode has deposits on it, polish it using emery paper. If the white insulator is cracked or chipped, the spark plug needs to be replaced. Use only NHSP®/Torch® F6TC spark plug. NOTICE: Using an incorrect spark plug may damage the engine. 4. When installing a new spark plug, adjust the plug's gap to the specification on the Technical Specifications chart. Do not pry against the electrode, the spark plug can be damaged. 5. Install the new spark plug or the cleaned spark plug into the engine. Gasket-style: Finger-tighten until the gasket contacts the cylinder head, then tighten about 1/2-2/3 turn more. Non-gasket-style: Finger-tighten until the plug contacts the head, then tighten about 1/16 turn more. NOTICE: Tighten the spark plug properly. If loose, the spark plug will cause the engine to overheat. If overtightened, the threads in the engine block will be damaged. 6. Apply dielectric spark plug boot protector (not included) to the end of the spark plug and reattach the wire securely. Setup Operation Maintenance Page 16 For technical questions, please call 1-888-866-5797. Engine for ITEM 62779
![](/manual_guide/products/harbor-freight-tools-62779-user-manual-d6fd3f6/56.png)