Hayward AquaRite 100 AquaRite 100 Owners Manual - Page 3

Introduction

Page 3 highlights

Introduction The AQR100 is an automatic chlorine generation system for pool sanitization. It is designed for inground swimming pools up to 30,000 gallons only. The AQR100 is NOT to be used with above ground pools or with inground pools greater than 30,000 gallons. The AQR100 requires a low concentration of salt (sodium chloride) in the pool water. It automatically sanitizes your pool by converting the salt into free chlorine which kills bacteria and algae in the water. Chlorine will revert back to sodium chloride after killing bacteria. These reactions will continuously recycle virtually eliminating the need to add sanitizing chemicals to your pool. The AQR100 can handle the purification needs of most residential swimming pools up to 30,000 gallons (113,000 liters). This unique low cost chlorine generator uses a replaceable electrolytic Cell that is designed to last for one pool season. NOTE: The actual amount of chlorination required to properly sanitize a pool varies due to bather load, rainfall, temperature, and the pool's cleanliness. NOTE: Before installing this product as part of a saline water purification system in a pool or spa using natural stone for coping or for immediately adjacent patios/decking, a qualified stone installation specialist should be consulted regarding the appropriate type, installation, sealant (if any) and maintenance of stone used around a saline pool with electronic chlorine generator in your particular location and circumstances. NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid regions where pool water is subject to excessive evaporation and is not commonly diluted with fresh water. Dry acid can cause a buildup of by-products that can damage your chlorinator Cell. 2 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
Introduction
The AQR100 is an automatic chlorine generation system for pool sanitization.
It is designed for
inground swimming pools up to 30,000 gallons only.
The AQR100 is NOT to be used with
above ground pools or with inground pools greater than 30,000 gallons.
The AQR100 requires a low concentration of salt (sodium chloride) in the pool water.
It automatically
sanitizes your pool by converting the salt into free chlorine which kills bacteria and algae in the water.
Chlorine will revert back to sodium chloride after killing bacteria. These reactions will continuously
recycle virtually eliminating the need to add sanitizing chemicals to your pool.
The AQR100 can handle the purification needs of most residential swimming pools up to 30,000
gallons (113,000 liters). This unique low cost chlorine generator uses a replaceable electrolytic Cell
that is designed to last for one pool season.
NOTE:
The actual amount of chlorination required to properly sanitize a pool varies due to bather
load, rainfall, temperature, and the pool’s cleanliness.
NOTE:
Before installing this product as part of a saline water purification system in a pool or spa
using natural stone for coping or for immediately adjacent patios/decking, a qualified stone instal-
lation specialist should be consulted regarding the appropriate type, installation, sealant (if any) and
maintenance of stone used around a saline pool with electronic chlorine generator in your particular
location and circumstances.
NOTE:
The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid regions
where pool water is subject to excessive evaporation and is not commonly diluted with fresh water.
Dry acid can cause a buildup of by-products that can damage your chlorinator Cell.