Hayward AquaRite 100 AquaRite 100 Owners Manual - Page 7

Wiring

Get Hayward AquaRite 100 PDF manuals and user guides View all Hayward AquaRite 100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Connect and Fasten Cell Cap Slip the Cell Cap through the Retaining Nut as shown below. Plug the Cell Cap into the Cell and secure with the Retaining Nut. Cell Cap Retaining Nut Wiring Power must be shut off at the circuit breaker before performing any wiring. Be sure to follow Local and NEC electrical codes. To provide safe operation, the AQR100 should be installed by a qualified service professional and must be properly grounded and bonded. The AQR100 can be powered by either 120 VAC or 240 VAC and must be wired in a manner that the AQR100 turns on and off with the pool pump. If the pump is connected to a timeclock or switch, wire the AQR100 in parallel. Locate the 6 ft. long five conductor cable coming from the Control Box. These five colored wires are used to select voltage and apply power to the AQR100. Refer to the wiring label on the AQR100 as well as the diagrams on the following page to determine correct wiring connections for either 120 VAC or 240 VAC. Cut the cable and conductors to length and ensure that all connections are made within a UL Listed junction box. Attach the junction box cover when wiring is complete. 6 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
6
Connect and Fasten Cell Cap
Slip the Cell Cap through the Retaining Nut as shown below.
Plug the Cell Cap into the Cell and
secure with the Retaining Nut.
Wiring
Power must be shut off at the circuit breaker before performing any wiring.
Be sure to follow Local
and NEC electrical codes.
To provide safe operation, the AQR100 should be installed by a qualified
service professional and must be properly grounded and bonded.
The AQR100 can be powered by either 120 VAC or 240 VAC and must be wired in a manner that
the AQR100 turns on and off with the pool pump. If the pump is connected to a timeclock or switch,
wire the AQR100 in parallel.
Locate the 6 ft. long five conductor cable coming from the Control Box. These five colored wires are
used to select voltage and apply power to the AQR100. Refer to the wiring label on the AQR100 as
well as the diagrams on the following page to determine correct wiring connections for either 120
VAC or 240 VAC.
Cut the cable and conductors to length and ensure that all connections are made
within a UL Listed junction box. Attach the junction box cover when wiring is complete.
Cell Cap
Retaining Nut