HP 350546-B21 HP StorageWorks Ultrium Tape Drive Removable Model Getting Start - Page 15

Step 2: Install the drive

Get HP 350546-B21 - StorageWorks Rack-Mount Kit Ultrium 460 Drive Tape PDF manuals and user guides
UPC - 808736773836
View all HP 350546-B21 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Step 2: Install the drive Airflow requirements for the tape drive are 6 cfm (0.17m3/minute or 10.08m3/hour) at up to 35 C ambient operation. This rises to 8 cfm for up to 40 C ambient operation. Ventilation must be adequate at the front and rear of the Tape Array unit to ensure that this is maintained. 1 Ensure that the extractor lever on the drive is in the out position, as shown in Figure 4. 2 Lift the drive carefully. 3 Align the rear of the drive with the guides on the side of the tape array. 4 Slide the drive along the guides, until the connectors on the back mate with the connectors at the back of the enclosure. 5 Push the extractor lever in until it locks the drive in position. The HP StorageWorks Tape Array 5300 is designed to provide adequate airflow for up to two full-height tape drives (like the HP StorageWorks Ultrium 230, 460 or 960 drives) or up to four half-height drives. If you are installing only one full-height drive in the tape array, you must use blanking plates in the unused bay. See the documentation with the tape array for details on installing blanking plates. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
13
Step 2: Install the drive
1
Ensure that the extractor lever on the drive is in the
out
position, as shown in Figure 4.
2
Lift the drive carefully.
3
Align the rear of the drive with the guides on the side of the tape array.
4
Slide the drive along the guides, until the connectors on the back mate with the connectors
at the back of the enclosure.
5
Push the extractor lever in until it locks the drive in position.
Airflow requirements for the tape drive are 6 cfm (0.17m
3
/minute or 10.08m
3
/hour) at up
to 35 C ambient operation. This rises to 8 cfm for up to 40 C ambient operation. Ventilation
must be adequate at the front and rear of the Tape Array unit to ensure that this is
maintained.
The HP StorageWorks Tape Array 5300 is designed to provide adequate airflow for up to
two full-height tape drives (like the HP StorageWorks Ultrium 230, 460 or 960 drives) or up
to four half-height drives. If you are installing only one full-height drive in the tape array, you
must use blanking plates in the unused bay. See the documentation with the tape array for
details on installing blanking plates.