HP 350546-B21 HP StorageWorks Ultrium Tape Drive Removable Model Getting Start - Page 21

Your HP StorageWorks Ultrium tape drive Your Ultrium tape drive has four LEDs (light emitting diodes) on the front panel, which indicate drive status. These LEDs provide useful troubleshooting information, see also "Understanding the LEDs" on page 40. See page 17 for more information about using the eject button in normal operation and page 44 for details about force eject and emergency reset. Front panel LEDs There are four LEDs as illustrated in the diagram. (See Figure 7.) Ready (top, green) • On: the drive is ready for use • Off: the drive power is off or there was a failure during self-test • Flashing: the drive is busy • Flashing repeated pattern: the drive is in OBDR mode Drive Error (second, amber) • Off: no fault has been detected • Flashing: the drive mechanism has detected a hardware error. Tape Error (third, amber) • Off: no fault has been detected • Flashing: the tape currently in the drive is faulty. This LED could come on for a number of reasons, but they all relate to the tape being in error in some way, such as unreadable cartridge memory or unsupported tape. Do not use the cartridge; replace it. The LED will go out when a tape load is started. Clean (Ultrium 960 and 460) or Use Cleaning Cartridge (Ultrium 230) - bottom, amber • On: cleaning cartridge in use • Off: the drive does not require cleaning • Flashing: the drive needs cleaning Accessibility features The front panel of the HP StorageWorks Ultrium 960 and 460 tape drive has been designed for increased accessibility for persons with disabilities. This includes larger font labeling of the Status LEDs and an Eject button that has been designed for ease of use. 19