HP 350546-B21 HP StorageWorks Ultrium Tape Drive Removable Model Getting Start - Page 24

Write-protecting cartridges, Cleaning cartridges, To clean the tape drive, Caring for cartridges

Page 24 highlights

Write-protecting cartridges If you want to protect the data on a cartridge from being altered or overwritten, you can writeprotect the cartridge. Always remove the cartridge from the tape drive before you change the write protection. • To write-protect a cartridge, slide the red tab by the label area on the rear face of the cartridge to close the hole. Note the padlock on the tab that indicates that the cartridge is protected. • To write-enable a cartridge, slide the red tab back so that the hole is open before loading it into the drive. Figure 8 illustrates the location of the write-protect tab. Write-protection will not prevent a cartridge being erased by bulk-erasure or degaussing. Do not bulk erase Ultrium format cartridges. This will destroy pre-recorded servo information and make the cartridge unusable. Cleaning cartridges You must use Ultrium cleaning cartridges with HP StorageWorks Ultrium tape drives, as other cleaning cartridges will not load and run. We recommend the HP Ultrium universal cleaning cartridge (see table 3). Unlike some earlier Generation 1 Ultrium cleaning cartridges, the orange-colored Ultrium universal cleaning cartridge is designed to work with any Ultriumcompliant drive. Do not use other format cartridges in your tape drive and do not use Ultrium cartridges in other format tape drives. Type of cartridge Cleaning Recommended cartridge HP Ultrium universal cleaning cartridge C7978A (Orange) Other options HP Ultrium 1 cartridge C7979A (Blue). Do not use other Ultrium 1 (IBM/Seagate) cartridges. table 4: cleaning cartridge compatibility To clean the tape drive HP StorageWorks Ultrium tape drives do not require regular cleaning. An Ultrium universal cleaning cartridge is supplied with each tape drive and should only be used when the orange Clean (Ultrium 960 and 460) or Use Cleaning Cartridge (Ultrium 230) LED is flashing. 1 Insert the Ultrium universal cleaning cartridge. 2 The drive will carry out its cleaning cycle and eject the cartridge on completion (which can take up to 5 minutes). During the cleaning cycle the orange Clean (Ultrium 960 and 460) or Use Cleaning Cartridge (Ultrium 230) LED will be on solidly and the green Ready LED will flash. Each HP Ultrium universal cleaning cartridge cleaning cartridge can be used up to 50 times with Ultrium 960 and Ultrium 460 tape drives, and up to 15 times with Ultrium 230 tape drives. (HP Ultrium 1 cleaning cartridges can only be used up to 15 times with any tape drive.) If the cleaning cartridge is ejected immediately with the Tape Error LED on, it has expired. Caring for cartridges It is important that you look after your HP media and adhere to the recommended guidelines. See "Looking after cartridges" on page 44. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50

22
Write-protecting cartridges
If you want to protect the data on a cartridge from being altered or overwritten, you can write-
protect the cartridge.
Always remove the cartridge from the tape drive before you change the write protection.
To write-protect a cartridge, slide the red tab by the label area on the rear face of the
cartridge to close the hole. Note the padlock on the tab that indicates that the cartridge is
protected.
To write-enable a cartridge, slide the red tab back so that the hole is open before loading
it into the drive. Figure 8 illustrates the location of the write-protect tab.
Write-protection will not prevent a cartridge being erased by bulk-erasure or degaussing.
Do
not bulk erase Ultrium format cartridges.
This will destroy pre-recorded servo information and
make the cartridge unusable.
Cleaning cartridges
You must use Ultrium cleaning cartridges with HP StorageWorks Ultrium tape drives, as other
cleaning cartridges will not load and run. We recommend the HP Ultrium universal cleaning
cartridge (see table 3). Unlike some earlier Generation 1 Ultrium cleaning cartridges, the
orange-colored Ultrium universal cleaning cartridge is designed to work with any Ultrium-
compliant drive. Do not use other format cartridges in your tape drive and do not use Ultrium
cartridges in other format tape drives.
table 4: cleaning cartridge compatibility
To clean the tape drive
HP StorageWorks Ultrium tape drives do not require regular cleaning. An Ultrium universal
cleaning cartridge is supplied with each tape drive and should only be used when the orange
Clean (Ultrium 960 and 460) or Use Cleaning Cartridge (Ultrium 230) LED is flashing.
1
Insert the Ultrium universal cleaning cartridge.
2
The drive will carry out its cleaning cycle and eject the cartridge on completion (which can take
up to 5 minutes). During the cleaning cycle the orange Clean (Ultrium 960 and 460) or Use
Cleaning Cartridge (Ultrium 230) LED will be on solidly and the green Ready LED will flash.
Each HP Ultrium universal cleaning cartridge cleaning cartridge can be used up to 50 times
with Ultrium 960 and Ultrium 460 tape drives, and up to 15 times with Ultrium 230 tape
drives. (HP Ultrium 1 cleaning cartridges can only be used up to 15 times with any tape
drive.) If the cleaning cartridge is ejected immediately with the Tape Error LED on, it has
expired.
Caring for cartridges
It is important that you look after your HP media and adhere to the recommended guidelines.
See “Looking after cartridges” on page 44.
Type of cartridge
Recommended cartridge
Other options
Cleaning
HP Ultrium universal cleaning
cartridge C7978A (Orange)
HP Ultrium 1 cartridge C7979A (Blue).
Do not use other Ultrium 1 (IBM/Seagate)
cartridges.