HP 4020 HP Designjet 4020 Printer series - Assembly Instructions: English - Page 4

21 22 23 24 Fix the left foot using four screws. 25 Position a foot on the right leg. There are pins to help you to position the foot correctly. Do not remove the anti-slip material from the wheel. Fix the right foot using four screws. You now need to identify the left and right of the printer. This information is shown on the foam end packs. Also identify the rear of the printer. 26 Left leg Right leg 27 28 x2 3m (9ft) Pull open the protective plastic from the base of the printer. Please ensure that there is a threemeter space clear of obstructions to the rear of the printer. Remove the two desiccant bags from the printer. Advance warning: in the next step, make sure you position the stand pins in the holes in the center of the printer body brackets. Lift the stand assembly onto the printer body. The anti-slip material should face to the rear of the printer. Fix the right side of the stand to the printer using one screw. Make sure that the screw is fully tightened.