HP 8/40 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01, July 2009) - Page 676
SWCH-1004, Message, Probable Cause, Recommended, Action, slotPowerOff, Severity, firmwareDownload
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 676 highlights
97 SWCH-1004 SWCH-1004 Message , [SWCH-1004], ,, ERROR, , Blade attach failed during recovery, disabling slot = . Probable Cause Indicates a blade has failed during failover or recovery. Recommended Action On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn command. On a Brocade 200E, 3250, 3850, 3900, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000, 7500, or AP7600 switch, reboot or power cycle the switch Severity ERROR SWCH-1005 Message , [SWCH-1005], ,, ERROR, , Diag attach failed during recovery, disabling slot = . Probable Cause Indicates the Diag blade attach has failed during failover or recovery. Recommended Action On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn command. On a Brocade 200E, 3250, 3850, 3900, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000, 7500, or AP7600 switch, reboot or power cycle the switch. Severity ERROR SWCH-1006 Message , [SWCH-1006], ,, WARNING, , HA state out of sync: Standby CP (ver = ) does not support NPIV functionality. (active ver = , NPIV devices = ). Probable Cause Indicates the standby control processor (CP) does not support N_Port ID Virtualization (NPIV) functionality and the switch has some NPIV devices logged into the fabric. Recommended Load a firmware version on standby that supports NPIV functionality, using the firmwareDownload Action command. Severity WARNING SWCH-1007 Message Probable Cause , [SWCH-1007], ,, WARNING, , Switch port disabled due to \"\". Indicates the switch port is disabled due to the reason displayed in the message. 606 Fabric OS Message Reference 53-1001338-01