HP 8/40 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01, July 2009) - Page 774
Sulb-1010, Sulb-1017, Sulb-1018
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 774 highlights
125 SULB-1010 In a director-class switch, when firmwareDownload fails, the two CPs may end up with different versions of firmware and they may not gain high-availability (HA) sync. In that case, run firmwareDownload single mode (-s) to upgrade the firmware on the standby CP to the same version as the active CP. Then retry firmwareDownload to download the desired version of firmware onto the CPs. Refer to the Fabric OS Administrator's Guide for troubleshooting information. Severity INFO SULB-1010 Message AUDIT, , [SULB-1010], INFO, FIRMWARE, , , , Firmwarecommit failed (status=0x). Probable Cause Indicates the firmwareCommit command has failed. The error code provides debugging information. See Table 11 for more information. Recommended If the failure is caused by an inconsistent filesystem, contact your switch service provider. Action Severity INFO SULB-1017 Message AUDIT, , [SULB-1017], ERROR, FIRMWARE, , , , Firmwaredownload failed in slot . Probable Cause Indicates the firmwareDownload command has failed in the specified blade. The error may be caused by an inconsistent AP blade firmware stored on the active CP. It may also be caused by an internal Ethernet issue or by a persistent storage hardware failure. Recommended Action Run the slotShow command. If the blade is in FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload to the blade. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1018 Message Probable Cause AUDIT, , [SULB-1018], ERROR, FIRMWARE, , , , Firmwaredownload timed out in slot . Indicates there may be an error caused by a blade initialization issue after the new firmware is downloaded and the blade is rebooted. The error may also be caused by an internal Ethernet issue or by a persistent storage failure. 704 Fabric OS Message Reference 53-1001338-01