HP A7533A HP StorageWorks Fabric OS 6.x administrator guide (5697-0015, May 20 - Page 137
Restoring a configuration
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Restoring switch information Run the commands listed in Table 42 and save the output in a file format. Store the files in a safe place for emergency reference. Table 42 CLI commands to display switch configuration information Command Displays configShow ipAddrShow licenseShow fosConfig iscsiCfg iscsiTargetName iscsiPortCfg isnsCfg fcLunQuery portCfgEXPort portCfgVEXPort fcrRouterPortCost fcrXlateConfig System configuration parameters and settings, including license information, zoning, and licensing information. The IP address. The license keys you have installed and provides better detail than the license information from the configshow command. Fabric OS features. iSCSI entities. The IQN prefix. The iSCSI port parameters. The configuration state of the iSNS client operation. A list of LUN IDs and LUNs for all accessible targets. EX_Port configuration parameters. VEX_Port configuration parameters. FC router route information A translate (xlate) domain's Domain ID for both EX_Port-attached fabric and backbone fabric. Restoring a configuration Restoring a configuration involves overwriting the configuration on the switch by downloading a previously saved backup configuration file. Make sure that the configuration file you are downloading is compatible with your switch model, because configuration files from other model switches might cause your switch to fail. The configuration download process is additive, that is, the lines read from the files are added to the current switch configuration. You can change a single configuration variable by downloading a file with that specific variable only. When you do so, all other variables remain unchanged. If your setup supports anonymous users, and you log in as an anonymous user, password is still a required field, even though its value may be ignored by the FTP service. If a configupload command is issued on a non-FCR platform, FCR-like parameters may be viewed in the uploaded data. This is harmless to the switch and can be ignored. Configuration download without disabling a switch Starting in Fabric OS 5.2.0, you can download configuration files to a switch while the switch is enabled, that is, you do not need to disable the switch for changes in SNMP, Fabric Watch, and ACL parameters. When you use the configDownload command, you will be prompted to disable the switch only when necessary. However, if there is any changed parameter that does not belong to SNMP, Fabric Watch, or ACL, then you must disable the switch. Configuration download without disabling a switch is independent of the hardware platform and supported on all hardware platforms running Fabric OS 5.2.0 and later. You may attempt to download a configuration file first without disabling the switch. If there is at least one changed parameter outside of SNMP, Fabric Watch, and ACL, you will be prompted to disable the switch before proceeding. Fabric OS 6.x administrator guide 137