HP A7533A HP StorageWorks Fabric OS 6.x administrator guide (5697-0015, May 20 - Page 234
cfgShow, cfgAdd, cfgEnable, lsanZoneShow, fcrPhyDevShow, fcrProxyDevShow
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 234 highlights
9. Enter the cfgShow command to verify that the zones are correct. switch:admin> cfgshow Defined configuration: zone: lsan_zone_fabric2 10:00:00:00:c9:2b:c9:0c; 50:05:07:61:00:5b:62:ed; 50:05:07:61:00:49:20:b4 Effective configuration: no configuration in effect 10. Enter the cfgAdd and cfgEnable commands to create and enable the LSAN configuration. switch:admin> cfgadd "zone_cfg", "lsan_zone_fabric2" switch:admin> cfgenable "zone_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. Do you want to enable 'zone_cfg' configuration (yes, y, no, n): [no] y zone config "zone_cfg" is in effect Updating flash ... 11. Log in as an admin and connect to the 4/256 SAN Director or DC Director with a FR4-18i blade. 12. Enter the following commands to display information about the LSANs. • lsanZoneShow -s shows the LSAN. switch:admin> lsanzoneshow -s Fabric ID: 2 Zone Name: lsan_zone_fabric2 10:00:00:00:c9:2b:c9:0c Imported 50:05:07:61:00:5b:62:ed EXIST 50:05:07:61:00:49:20:b4 EXIST Fabric ID: 75 Zone Name: lsan_zone_fabric75 10:00:00:00:c9:2b:c9:0c EXIST 50:05:07:61:00:5b:62:ed Imported • fcrPhyDevShow shows the physical devices in the LSAN. switch:admin> fcrphydevshow Device WWN Physical Exists PID in Fabric 75 10:00:00:00:c9:2b:c9:0c c70000 2 50:05:07:61:00:5b:62:ed 0100ef 2 50:05:07:61:00:5b:62:ed 0100e8 Total devices displayed: 3 • fcrProxyDevShow shows the proxy devices in the LSAN. switch:admin> fcrproxydevshow Proxy WWN Proxy Device Physical State Created PID Exists PID in Fabric in Fabric 75 50:05:07:61:00:5b:62:ed 01f001 2 0100e8 Imported 2 10:00:00:00:c9:2b:c9:0c 02f000 75 c70000 Imported Total devices displayed: 2 On the 4/256 SAN Director or DC Director with an FR4-18i blade, the host and Target A are imported, because both are defined by lsan_zone_fabric2 and lsan_zone_fabric75. However, target B defined by lsan_zone_fabric75 is not imported because lsan_zone_fabric2 does not allow it. When a PLOGI, PDISC, or ADISC arrives at the 4/256 SAN Director or DC Directory with an FR4-18i blade, the SID and DID of the frame are checked. If they are LSAN-zoned at both SID and DID edge fabrics, the frame will be forwarded to the DID. If they are not zoned, only the PLOGI is dropped; for the remaining frames zoning enforcement takes place in the edge fabrics. 234 Using the FC-FC routing service