HP AE370A HP StorageWorks Fabric OS 6.x administrator guide (5697-0015, May 20 - Page 293

Viewing equipment status You can display status for fans, power supply, and temperature. NOTE: The number of fans, power supplies, and temperature sensors depends on the switch type. For detailed specifications on these components, refer to the switch hardware reference manual. The specific output from the status commands varies depending on the switch type. To display the status of the fans: 1. Connect to the switch and log in as admin. 2. Enter the fanShow command: switch:admin> fanshow Fan 1 is OK speed is 7010 RPM Fan 2 is OK speed is 7180 RPM Fan 3 is OK speed is 7068 RPM Fan 4 is OK speed is 7116 RPM Fan 5 is OK speed is 7155 RPM Fan 6 is OK speed is 7001 RPM switch:admin> The possible status values are: • OK-Fan is functioning correctly. • Absent-Fan is not present. • Below minimum-Fan is present but rotating too slowly or stopped. • Above minimum-Fan is rotating too quickly. • Unknown-Unknown fan unit installed. • FAULTY-Fan has exceeded hardware tolerance. To display the status of a power supply: 1. Connect to the switch and log in as admin. 2. Enter the psShow command: switch:admin> psshow Power Supply #1 is OK 0335,FF2Z0007161,60-0000739-02, B,,DCJ3002-01P, B,FF2Z0007161 Power Supply #2 is faulty 0335,FF2Z0007176,60-0000739-02, B,,DCJ3002-01P, B,FF2Z0007176 switch:admin> The possible status values are: • OK-Power supply functioning correctly. • Absent-Power supply not present. • Unknown-Unknown power supply unit installed. • Predicting failure-Power supply is present but predicting failure. • FAULTY-Power supply is present but faulty (no power cable, power switch turned off, fuse blown, or other internal error). To display temperature status: 1. Connect to the switch and log in as admin. Fabric OS 6.x administrator guide 293