HP AE370A HP StorageWorks Fabric OS 6.x administrator guide (5697-0015, May 20 - Page 334

Domain 1 8 1 9 2 Domain 3 9 10 12 11 87 6 = Dedicated path = Ports in the TI zone Figure 24 TI zone misconfiguration 5 Domain 4 Supported configurations for Traffic Isolation Note the following configuration rules for TI zones: • Traffic Isolation is supported only on the HP StorageWorks 4/8 SAN Switch, 4/16 SAN Switch, SAN Switch 4/32, 4/64 SAN Switch, SAN Switch 4/32B, and 400 Multi-protocol Router, 4/256 SAN Director and DC SAN Backbone Director (short name, DC Director), all configured in Brocade Native Mode (interopmode 0). • Traffic Isolation has limited support for FICON FCIP in McDATA Fabric Mode (interopmode 2), in the following configuration only: NOTE: At the time of this document's release, HP does not support McDATA Fabric Mode (interopmode 2). • 400 Multi-protocol Router with E_Port connections to an M-switch and VE_Port connections to another 400 Multi-protocol Router. • Devices attached to M-switch only. • Traffic Isolation is not supported in fabrics configured in Open Fabric Mode (interopmode 3). • Limited USD-X replacement support for FICON FCIP in McDATA Fabric Mode. • 400 Multi-protocol Router (platform specific) with E-port connections to an M-switch and VE-port connections to another 400 Multi-protocol Router. • Devices attached to M-switch only. This feature is not supported in fabrics configured in any interopMode except for a predefined FICON FCIP configuration in McDATA Fabric Mode. • VE_Ports are supported in TI zones. • FCR does not support Traffic Isolation. • Ports in a TI zone must belong to switches that run Fabric OS v6.0 or later. • Traffic Isolation is not supported in fabrics with switches running firmware versions earlier than Fabric OS 6.0. However, the existence of a TI zone in such a fabric is backward compatible and does not disrupt fabric operation in switches running earlier firmware versions. 334 Optimizing fabric behavior