HP Cisco Catalyst Blade Switch 3020 Release Notes for Cisco Catalyst Blade Swi - Page 14

Resolved Caveats • CSCso57496 A switch no longer fails when you enter the configure replace privileged EXEC command, and a banner is already present in the switch configuration. • CSCso90107 You can now query the bgpPeerTable MIB for VPN/VRF interfaces. • CSCsq51052 The output of the show ip ssh privileged EXEC command no longer displays SSH Enabled version 2.99. Instead, a correct SSH version (1.5, 1.99 or 2.0) now appears. • CSCsx49718 Re-authentication now occurs on a port under these conditions: - The port is in single-host mode. - The port is configured with the authentication event no-response action authorize vlan vlan-number command. - An EAPOL start packet is sent to the port. • CSCsy66686 The switch no longer reloads when the default port cost of service (CoS) value is updated on a port that has a policy map configured and CoS override enabled with the mls qos cos override privileged EXEC command. • CSCsy72669 If a link failure occurs on a secondary edge port, preemption now occurs after the link comes up. • CSCsz12381 When open1x authentication and MAC authentication bypass are enabled on a port, an IP phone is connected to the port, and DHCP snooping is enabled on the switch, DHCP traffic is now forwarded on the voice VLAN before open 1x authentication times out and the switch uses MAC authentication bypass to authorize the port. • CSCsz13490 The switch no longer reloads when you enter several key strokes while in interface-range configuration mode. • CSCsz14369 If MAC authentication bypass is enabled and the RADIUS server is not available, the switch now tries to re-authenticate a port after a server becomes available. • CSCsz77920 If you are configuring Flexible Authentication Ordering with web authentication on a switch port and the switch uses 802.1x to authenticate the host, Address Resolution Protocol (ARP) now works properly. • CSCsz79652 A memory leak no longer occurs when Cisco Network Assistant is polling the switch and the ip http server or ip http-secure-server global configuration command is enabled. • CSCta32597 A switch no longer fails when a host moves from a dynamically assigned VLAN to a configured VLAN. Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later 14 OL-18274-02