HP Cisco Catalyst Blade Switch 3020 Release Notes for Cisco Catalyst Blade Swi - Page 16

Resolved Caveats • CSCsy41470 The switch no longer runs out of memory when an smnpwalk, snmpget, or snmpbulkwalk is run on the CISCO-ENERGYWISE-MIB. Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE • CSCsq26873 The server no longer attempts re-authentication every ten minutes when a switch is configured with the dot1x timeout reauth-period server interface configuration command. • CSCsq67398 Traffic is now forwarded to the interfaces that are configured with static multicast MAC addresses after the switch is reloaded. Note You cannot configure the static MAC address (unicast or multicast) entries on EtherChannel member interfaces, or add an interface into the EtherChannel if that interface is associated with a static MAC address entry. • CSCsq89564 If the switch uses 802.1x authentication with VLAN assignment, it no longer uses the VLAN assignment with different authorization attempts, such as user authentication or re-authentication. • CSCsr50766 When keepalive is disabled on an interface, the interface is no longer put in an error-disabled state when it receives keepalive packets. • CSCsr64007 The Switched Port Analyzer (SPAN) destination port no longer detects IPv6 multicast packets from a VLAN that is not being monitored by SPAN. • CSCsr65689 This message no longer appears in the log during the system bootup on a switch that is running Cisco IOS 12.2(50)SE: • CSCsu10065 When SFP ports are configured as status multicast router ports, IPv6 Multicast Listener Discovery (MLD) snooping now works after the switch reloads. • CSCsu45951 A link is now established between a server and a switch when the server port is configured to not autonegotiate the speed. • CSCsu59214 The Set TxPortFifo SRR Failed message no longer appears when you enter both the srr-queue bandwidth shape 200 0 2 200 and the priority-queue out interface configuration commands on the same interface. • CSCsu88168 The switch no longer reloads when the Forwarding Information Base (FIB) adjacency table is added. Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later 16 OL-18274-02