HP Cisco Catalyst Blade Switch 3020 Release Notes for Cisco Catalyst Blade Swi - Page 17

Documentation Updates • CSCsv63345 When you enter the show interface command, the bandwidth and delay fields now display correct information for all ports. • CSCsv64023 A switch port configured for IGMP snooping no longer lose its group membership when the port receives a query comes from an upstream device that is not configured for IGMP snooping. • CSCsv89005 A switch configured with class-based policies that are applied and active on at least one interface no longer might reload or display CPU hog messages during SNMP polling for the ciscoCBQosMIB. • CSCsv91358 When you have entered the vlan dot1q tag native global configuration command to configure a switch to tag native VLAN frames on 802.1Q trunk ports, and you configure a new voice VLAN on an access port, the MAC address of a connected PC is now correctly relearned. • CSCsw30249 When a switch virtual interface (SVI) is configured as unnumbered and is pointing to a loopback interface, the switch no longer fails when the SVI receives a packet. • CSCsw45337 When LLDP is enabled and a voice VLAN is configured, the L2 Priority and DSCP Value fields in the LLDP type, length, and value descriptions (TLVs) are now correctly marked to give the voice traffic the correct DSCP and Layer 2 priority. • CSCsw65548 Switch ports no longer attempt authentication at the interval configured for the port security timer instead of the configured IEEE 802.1x timer. • CSCsw68528 On switches running Cisco IOS Release 12.2(44)SE or 12.2(46)SE, when you enter the show mvr interface interface-id members privileged EXEC command to see status of an MVR port, an MVR member port that is not connected always shows as ACTIVE. The workaround is to use the show mvr interface interface-id or the show mvr members privileged EXEC command. These command outputs show the correct status of an MVR port. • CSCsw69015 When you enter the mvr vlan vlan-id global configuration command to create an MVR VLAN and enable MVR on the switch by entering the mvr global configuration command, if you enter the show mvr interface interface-id members privileged EXEC command, the output shows the MVR groups on the interface. However, if you enable MVR first and then create the MVR VLAN, the MVR groups are not displayed correctly. The workaround, if the groups are not displaying correctly, is to create the MVR VLAN before enabling MVR. The configuration then displays correctly. • CSCsx27883 The MIB chassisPs2Status no longer returns the incorrect value, 1, for a secondary power supply. Documentation Updates • "Updates to the Command Reference" section on page 18 OL-18274-02 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later 17