HP DL165 HP ProLiant DL165 Generation 5 Software Configuration Guide - Page 33
Recording custom Setup values, Loading system defaults, Clearing CMOS, Power-On Self-Test (POST
![]() |
UPC - 884962026601
View all HP DL165 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Recording custom Setup values Write down the settings from the Setup Utility and keep them in a safe place. If the custom values ever need restoring (after clearing CMOS, for example), you must run the Setup Utility and enter these custom settings again. Having a record of these custom settings makes this much easier. Loading system defaults If the system fails after you make changes in the Setup menus, reboot the server, enter Setup, and load the system default settings to correct the error. These default settings have been selected to optimize the server's performance. Setup default settings are quite demanding in terms of resource consumption. If you are using low-speed memory chips or other types of low-performance components and you choose to load these settings, the system might not function properly. To load the system defaults: 1. Reboot the server in a normal manner. 2. During POST, press F10 to access the Setup Utility. 3. Press F9 to load the default values. 4. Press F10 to save the changes and close the Setup Utility. Clearing CMOS You may need to clear the Setup configuration values (CMOS) if the configuration has been corrupted, or if incorrect settings made in the Setup Utility have caused error messages to be unreadable. Clearing the CMOS data removes the administrator password. The clear CMOS setting is on clear CMOS button (SW2) on the system board. Refer to the HP ProLiant DL165 Generation 5 Server Maintenance and Service Guide for the location of this jumper block and the clear CMOS setting. To clear CMOS: 1. Perform the pre-installation procedures. 2. If necessary, remove any expansion boards, assemblies, or cables that prevent access to the press CMOS button (SW2). 3. Locate the clear CMOS button (SW2) on the system board. 4. Press clear CMOS button (SW2) to clear the CMOS memory. 5. Perform the post-installation procedures. 6. During POST, press F10 to access the Setup Utility. 7. Press F9 to load the system default values. 8. Press F10 to save the changes you made and close the Setup Utility. Power-On Self-Test (POST) When the server boots up, a series of tests are displayed on the screen. This is referred to as PowerOn Self-Test (POST). POST is a series of diagnostic tests that checks firmware and assemblies to ensure that the server is properly functioning. This diagnostic function automatically runs each time the server is powered on. System BIOS configuration 33
![](/manual_guide/products/hewlettpackard-dl165-hp-proliant-dl165-generation-5-software-configuration-guide-0e7289e/33.png)